Pairing The Btx1 Pro To Bluetooth Devices - Midland BTX1 PRO Guide D'utilisation

Pairing the BTX1 PRO to Bluetooth devices

The BTX1 PRO Conference unit can be paired to other Bluetooth devices, like Pho-
ne, GPS Navigator or PMR446 Radio with built-in or external Bluetooth (dongle).
The pairing procedure must be done using the "Volume +" or the "Volume -" buttons.
› Pairing to the "Volume +" button: for Phone with music A2DP stereo, GPS Navigator
with A2DP audio or external mono/Stereo A2DP dongle.
› All devices paired to "Volume +" button have higher priority and will interrupt all the
other communications (like Intercom, FM Radio and Music).
› Pairing to the "Volume -" button: for a second phone with mono audio (Hands Free
Protocol) for GPS navigators/ Radar detector and other devices with mono audio.
When a device is paired to the "Vol +" or "Vol –" buttons the "Phone" mode is activated.
MONO
› Phone (HFP Mono)
› GPS mono
› PMR446 Transceiver
Attention: A2DP audio source are supported only on Vol+. The second phone paired on Vol-
can support only mono audio (HFP).
Background feature
It is possible to keep always in background the audio of the device paired on Vol- button.
In this way the Intercom communication will not be interrupted, for example, by the
GPS's street indication or other audio mono device.
To activate the "Background" feature just press long the "Vol-" button, the voice "Back-
ground ON" will tell you that now is active.
To deactivate the "Background" feature just press again long the "Vol-" button, the
voice "Background disable" will tell you that now is not active anymore.
By default the "Background" feature is off.
www.midlandeurope.com
MONO e STEREO
› Phone (HFP/A2DP Stereo)
› GPS (HFP/A2DP Stereo)
› Dongle (HFP/A2DP Stereo)
Attention: we can't guarantee this feature because it is depending on third part device.
Pairing with one or two phones
The cellular phone can be paired to the "Vol +" (if the support for stereo A2DP is reque-
sted) or to the "Vol –".
When a phone is paired to the "Vol +" or "Vol-" the "Phone" mode is activated.
An incoming call has always the higher priority, that means all other communications will
be closed (Intercom, FM Radio, Music).
If another incoming call will arrive on the second phone, an alert sound will notify it.
How to pair the BTX1 PRO to a Phone
To pair the BTX1 PRO to a Phone, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on perma-
nently.
3. Now press for 3 seconds the "Volume +" or "Volume -" button, the Blue and Red light
will flash.
4. Enable the Bluetooth device search feature on your mobile phone
5. After some seconds, "Midland BTX1 PRO" will be displayed on your mobile phone.
Follow the pairing procedure of your Phone. If a pin code is requested you must enter
"0000" (four time zero).
When successfully paired, the Blue light of the unit will be on for one second and then
the unit will exit the setup mode and switch to the working mode (the Blue light will start
flashing).
You can use now your BTX1 PRO together with the Phone.
How to use a Phone
After pairing your phone to the BTX1 PRO unit you must switch to the "Phone" mode in
order to use it. Press the middle button until you hear "Phone" from the voice announcement.
Now all the three main buttons are dedicated to the phone (see Table B)
Answering a call
When you hear the phone ring, you can answer in two different ways:
Vocally:
21