Wired Audio Input - Midland BTX1 PRO Guide D'utilisation

Press short the Forward or the Backward button to seek the FM Radio station. When
you press long the Forward or the Backward button, you can scan up or down the 6
recorded stations. A voice announcement will tell you the number of which memory you
are entering.
To save the station you are listening, press the Forward and Backward buttons together
for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal available for
the radio station you like to listen.
The RDS system is OFF by default, if needed you can toggle on/off the RDS pressing
together the "Volume +" and "Volume –" buttons for 3 sec when the radio is on. A voice
announcement will tell you the RDS status.
FM Radio with intercom
When you are in "FM Radio" mode is not possible to manually open the intercom, you can
only open it using VOX feature (just talk) to the unit paired on the "Middle" button. To
manually activate the intercom you must switch to "Intercom" mode.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about 7
sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will flash
three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the BTX1 PRO.
Enabling:
Radio FM mode
Mode
FM Radio
24
Forward button
Short press: seek station up
Long press: Scan recorded
› Follow the same procedure up described; now the blue LED will flash once.
› To exit the "Setup" mode, double click the "Middle" button.
Pairing to a PMR446 radio with integrated or external Bluetooth
The PMR446 Radio can be paired to the "Volume +" or "Volume -" button. If paired on
"Volume -" and the "Background" feature is activated, the PMR446 radio is always in
the background even when you talk on the intercom.
Pairing procedure
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on perma-
nently.
› Now press firmly (3 sec) the "Vol +" or "Vol -" button, the Blue and Red light will flash.
› Follow now the pairing procedure explained on the manual of the transceiver itself.

Wired audio input

Your Midland BTX1 PRO can be connected to a wired audio source, like an iPod (or any
other MP3 Player).
Listening to music
To listen to music from the wired input, connect the audio source using the optional
AUX cable.
The volume buttons (Vol + and Vol -) can be used to adjust the volume of the wired
audio source (but not independently from the Intercom Volume). The AGC system will
automatically increase the volume on higher speed.
Attention: never set the volume of the MP3 Player to the maximum possible. Normally the
best level is about the 70% of the maximum.
Middle button
Short press: On/off
Long press: Change mode
Backward button
Short press: seek station down
Long press: Scan recorded
www.midlandeurope.com