ChefLine PYRALIS Notice D'utilisation page 52

1 SAFETY RECOMMENDATIONS
WARNINGS FOR THE INSTALLER
Check that the location of the oven is in compliance with local, national and European regulations.

Adhere to the instructions in this manual.

Do not execute electrical connections using temporary or uninsulated cables.

Check that the ground connection of the electrical system is functioning properly.

Always use individual safety devices and other means of protection in compliance with the law.
WARNING FOR THE USER
The conditions in the surrounding area where the machine will be installed must have the following
characteristics:

the area must be dry;

the area must have water and heat sources at an adequate distance;

ventilation and lighting must be suitable and comply with the hygiene and safety standards foreseen
by current laws;

the floor must be flat and compact to facilitate thorough cleaning;

there must be no obstacles of any kind in the immediate vicinity of the machine that could effect the
machine's normal ventilation.
In addition, the user must:

make certain to keep children away from the machine when it is operating;

adhere to the instructions in this manual.

not remove or tamper with the safety devices on the machine;

always pay careful attention to the work at hand and not use the machine when in a distracted state;

perform all operations with maximum safety and calm;

respect the instructions and warnings displayed on the machine labels.
The labels are accident prevention devices, and therefore must always be perfectly legible. If these should
be damaged and illegible, it is mandatory to replace them by requesting replacements from the
Manufacturer.

At the end of each working shift, before cleaning, maintenance or transfer operations, disconnect
electrical power.
WARNINGS FOR THE MAINTENANCE OPERATOR
Observe the instructions indicated in this manual.

Always use individual safety devices and other protection means.

Before starting any maintenance operations, make sure that the oven, it was used, is cooled down .

If any of the safety devices is worn or faulty, the oven is also considered faulty and not to be used.

Disconnect electrical power before intervening on electrical or electronic parts and connectors.
- 52 -