Equipment And Accessories; Starting Procedure; Adjustment Of Mandrel Length "X - Gesipa GBM 95 Mode D'emploi

5.

Equipment and accessories

Threaded mandrel and nosepieces: M6 in working position
Tools:
Other:
6.

Starting procedure

Before starting, carefully read and follow operating instructions!
6.1

Adjustment of mandrel length "X"

• Disconnect tool from compressed air to unlock the threaded mandrel.
• In case of standard blind rivets nuts «a» the protruding part of the threaded mandrel (2)
must be as long as the whole blind rivet nut (see drawing 1) and is hand adjusted by
turning the mandrel either in or out.
• In case of closed-end rivet nuts «b» use entire threaded depth.
• To lock the length adjustment connect tool to compressed air and the locking device is
engaged automatically.
Drawing 1
Alternatively also M3, M4, M5, M8 and M10
Universal maintenance wrench MSU
Pin spanner Ø 42
Hexagon screw driver SW 4 mm
Hexagon ball-end driver SW 2.5 mm
Assembly rod
Hydraulic oil refill bottle
Operating manual with spare part list
3
2 1
GB
17