REBER ART.: 9600 N – 96xx Nxy - 8710 N - 8820 N - 8410 N - 8910 N - 8310 N ART.: 9601 N - 90xx Nxy – 95xx Nxy ART.: 9602 N – 92xx Nxy Notice D'utilisation Et Entretien page 45

must not be placed in the refrigerator before extrusion.
to avoid damaging the propeller and the gears.
operations should be carried out with the motor off and with the plug
cable disconnected.
You are advised to push the mix with your hands in the press body.
You are advised, after use, to dismantle, wash and carefully dry each
part of the press.
You are advised to clean the die plates by soaking them in a bowl of
tepid water immediately after use.
You are advised to heat the die plates in hot water before use (cold die
plates cause the pasta to come out in an irregular shape).
tones, based on the output pressure; it is lighter if there is less pressure
(for example if the pasta is inserted in the body too slow for the
quality and characteristics of the pasta.
the motor and immediately remove the plug from the socket, dismantle
the accessory and clean it to eliminate blockage that caused the jam.
WARNINGS