REBER ART.: 9600 N – 96xx Nxy - 8710 N - 8820 N - 8410 N - 8910 N - 8310 N ART.: 9601 N - 90xx Nxy – 95xx Nxy ART.: 9602 N – 92xx Nxy Notice D'utilisation Et Entretien page 44

Switch off the motor when the mix to extrude has terminated.
Pasta extruded at home can be eaten immediately or frozen for future use; freezing
avoids possible pasta breakage (especially large sized pasta) due to incorrect drying
at ambient temperature.
DIE PLATE REPLACEMENT
Switch off the motor and disconnect the plug from the current socket.
Unscrew the ring nut (11) by turning it in an anti-clockwise direction.
Remove the die plate (9) to replace and insert a new one.
direction.
eliminating any pasta residue from the holes.
DISMANTLING AND CLEANING THE PRESS
with accurate cleaning of all its parts.
Switch off the motor and disconnect the plug from the current socket.
remove it from its position.
Unscrew the ring nut (11) by turning it in an anti-clockwise direction.
Remove the die plate (9) and the propeller (8) removing them from the front part of
PRESS ASSEMBLY
Switch off the motor and disconnect the plug from the current socket.
Insert the propeller (8) in the press casing (7), ensuring the square part exits from the
rear hole on the casing.
Insert the extruder (9) so the wider base enters in the inlet of the body (7). Screw in
the ring nut (11) on the inlet of the body (7) turning it in a clockwise direction up
to locking.
Couple the press to the gearmotor, so the square part of the propeller is inserted
in the square compartment of the gearmotor, and fasten it by fully screwing in the
fastening nuts.