REBER ART.: 9600 N – 96xx Nxy - 8710 N - 8820 N - 8410 N - 8910 N - 8310 N ART.: 9601 N - 90xx Nxy – 95xx Nxy ART.: 9602 N – 92xx Nxy Notice D'utilisation Et Entretien page 36

Cast iron casing treated with epoxy paint suitable for contact with food, towing pin
spring must always be installed between the pin and the propeller.
residual humidity in tomatoes and, as a result, on appliance functioning and the
end result; a biological product is always different season after season.
If the tomato is cooked, leave it to cool slightly and insert it in the machine at a
the neck of the casing without having to press them.
You are always advised to leave the tomatoes to drain (both cooked and raw) to
remove plant water; this procedure will avoid overly moist peel exiting and the risk
of liquid leaking from the rear of the body.
insert the tomato in the funnel, allow it to fall into the casing with the pestle without
autonomously, the pressed tomato will be correctly consistent and you can avoid
excessively wet peel exiting (a second pressing can however take place if the peels
are very moist).
Pressing the tomato with the pestle when the propeller is already full of tomato can
cause the liquid to leak from the rear of the body, damaging the reducer: leaving the
propeller to drain without pressing will avoid this problem.
request.
to insert the towing pin with the spring in the hole of the body in cast iron (9),
insert the propeller (10) in the body in cast iron by inserting it on the towing pin,
cast iron body. Screw the funnel (8) onto the threaded neck of the cast iron body
remove the propeller (10) and the towing pin with the spring. Remove the cast