Life & Mobility MATCH AURA Mode D'emploi page 32

Inspired by life
Faults
Fault table battery indicator
Number of Situation
flashing
indicator strips
1, fast Poor connection with the battery
or battery empty. Try to charge the
battery. If this does not help, alert
the dealer.
1, 1x per sec Battery almost empty. Charge
immediately.
2 Poor connection in the motor
cabling. Alert the dealer.
3 Short circuit in the motor cabling.
Alert the dealer.
4 Fault in the controller. Alert the
dealer.
5 Fault in the controller. Alert the
dealer.
6, 1x per 4 sec. Push assist in sleep mode. Switch
short flash the push assist off and then on again
to end the sleep mode.
6, fast The battery charger is connected.
Switch the push assist off and then
on again in order to be able to drive.
7 Control lever operated during
switching on. Release the control
lever and switch on again. If this
does not help, alert the dealer.
8 Fault in the controller. Alert the
dealer.
9 The brakes are set in free-wheel
position. Set both free-wheel levers
upwards in order to activate the
brakes.
Switch the push assist off and then
on again in order to be able to drive.
10 Battery charge too high. Alert the
dealer.
EN30
Fault table other situations
Number of flashing Situation
indicator strips
Indicator stays off even The battery is empty.
though the push assist is Charge the battery. If this
activated does not help, alert the
dealer.
Light bar runs from 1 to Control lever operated
10 lamps and back during switching on.
Release the control lever. If
this does not help, alert the
dealer.
Signal lamps on the battery charger
Lamp Situation
Red Battery is being charged.
Flashing red Battery voltage is too
low; discharged too
deeply.
The maximum charge
time of 7 hours has been
exceeded; charging will
be suspended.
Green Battery is full (with just a
little floating charge).
Flashing green Battery is completely full
and accepts no more
charge.
No battery is connected.
Alternating flashing red The charger alternates
and green between charge and
after-charge; this process
repeats itself a number
of times until the battery
is completely full (light is
green).
Faults
EN31