RIDGID R4512 Manuel D'utilisation page 50

MAINTENANCE
CLEANING THE DUST CHUTE
Clean the dust chute periodically to remove sawdust.
 Using a 4 mm hex key, remove the screws that secure
the back panel.
 Inspect the dust chute and attached dust collection
devices to clear away sawdust or other debris.
 Replace the back panel.
TO REMOVE AND CHANGE BELT
See Figure 80.
 Lower the saw blade.
 Using a 4 mm hex key, remove the screws that secure
the back panel.
 With a 6 mm hex key, loosen the bolt above and to the
right of the belt.
 Pull the belt off the pulleys.
 Insert a long flat blade screwdriver as shown.
 Holding the screwdriver in place, pull the new belt over
both pulleys, making sure it is properly placed.
 Remove the screwdriver.
 Tighten the bolt.
50 - English
BOLT
HEX
KEY
SCREWDRIVER
Fig. 80