RIDGID R4512 Manuel D'utilisation page 23

ASSEMBLY
 Place the assembled rail sections on a flat surface and
make sure the rail lies flat and level. There should be no
gaps between the two sections.
 Securely tighten all set screws.
To assemble the rear rail:
 Slide the remaining rail connector bar into the slot in the
a rear rail section.
 Assemble the rear rail sections in the same way as the
front rail. Make sure the rail lies flat and level and there
are no gaps between the two sections.
 Securely tighten all set screws.
INSTALLING THE RAILS ONTO THE SAW
TABLE
See Figures 29 - 32.
 Take the following from the large fastener pack:
9 Hex head bolts (M8 x 30 for the front rail)
9 Bolts (M8 x 20 for the rear rail)
16 Nuts (M8: 10 for the front rail, 6 for the rear rail)
NOTE: One M8 x 30 bolt, one M8 x 20 bolt, and four of
the nuts will be needed to secure the spreader bar to the
front and rear rails.
To install the front rail:
 Slide eight hex head bolts into the groove on the back
of the assembled front rail.
 Align the bolts with and insert the bolts into the holes on
the front of the saw table and table extensions.
 Using a 13 mm wrench, tighten the four center nuts. Do
not tighten completely.
 Tighten the four outer nuts. Do not tighten completely.
To install the rear rail:
 Insert eight bolts into the holes on the back of the saw
table and table extensions.
NOTE: Position the rear rail with the slotted side on the
bottom and the lip on the top and facing out.
 Using a 6 mm hex key, tighten the four center bolts. Do
not tighten completely.
 Tighten the four outer nuts. Do not tighten completely.
To check the table and rail position:
 Turn the height adjusting handwheel clockwise to raise
the blade.
 Gently place the rip fence against the blade as shown.
The mark on the right side indicator should be at zero on
the rip scale.
NOTE: Do not lock the rip fence handle at this point.
 If the rip fence indicator is not at zero, slightly loosen the
bolts and nudge the rails until the mark is at zero.
 Carefully tighten the four center nuts for the rail.
HEX NUT
HEX HEAD
BOLT
BOLT
LIP
BLADE
23 - English
REAR RAIL
SCREWS
RIP FENCE
RIP FENCE
INDICATOR
SCALE
FRONT RAIL
Fig. 29
Fig. 30
ZERO
Fig. 31