EINHELL Royal ART 14,4-2 Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
ANLEITUNG ART 14,4-2
22.09.2003
Avoid contact with leaky batteries. In the event of
contact, wash the affected area of skin
immediately with water and soap. If battery acid
gets in your eye, rinse out the eye with water for
at least 1 minute and consult a doctor at once.
Protect the battery charger and cable from
damage and sharp edges. Damaged cables are
to be replaced without delay by an electrician.
Do not charge the battery with other makes of
battery charger.
Improper use with other charging stations and
battery equipment may damage the battery and
result in injury.
Never charge the battery at temperatures below
10°C and over 40°C.
Do not keep the battery in a room in which the
temperature is higher then 50°C.
Never short-circuit the battery contacts.
Never touch the battery contacts with metallic,
conductive objects. Risk of short-circuiting!
Never place the battery in a container with
metallic, conductive objects. Risk of short-
circuiting!
Short-circuiting of the battery may cause the
battery cells to burn or explode!
Never leave the battery in the rain.
Before you switch on the tool, make sure that
there are no stones or other objects touching the
nylon line.
Always wear suitable clothing to protect your
head, hands and feet from injury. Wear a helmet,
goggles or visor, high boots or strong shoes, long
trousers made of tough material, and work
gloves.
Be sure to hold the tool away from your body
when it is switched on!
If the tool is turned over or if it is not in working
position, do not switch it on.
Switch off the motor when you are not using the
tool, when you leave the tool unattended, when
you are checking the tool, if the power cable is
damaged, when you want to remove and replace
the reel, and when you are moving the tool to
another location.
Keep the tool away from other persons,
particularly children and pets. There may be
stones and other objects in the flying cut grass.
Keep at least 5 m away from other persons and
animals when you are working with the tool.
To prevent injury to yourself and damage to the
tool, never cut against hard objects.
Use the edge of the guard to keep the tool away
from walls, changes of surface and fragile
objects.
Never use the tool without a guard.
8:09 Uhr
Seite 13
GB
CAUTION! The guard is vital for your safety
and for the safety of others, and it is also
essential for the grass trimmer to work
correctly. Failure to observe this instruction
will not only create a potential hazard, it will
also result in the loss of your rights under the
warranty.
Never try to stop the cutter (nylon line) with your
hands. Wait until it stops by itself. It is imperative
to use only the original nylon line.
Never use metal wire instead of the nylon line.
Beware of injuring yourself on the line cutting
device. Keep the air vents clear of dirt. After use,
unplug the machine and check it for damage.
Never attempt to cut grass that is not growing on
the ground. For example, do not try to cut grass
growing on walls, rocks, etc. Within the working
radius of the grass trimmer the user is
responsible for any damage caused to third
persons by use of the trimmer.
Never cross roads or pebble paths with the grass
trimmer switched on. When you are not using the
grass trimmer, keep it in a dry place out of the
reach of children.
Use the grass trimmer only as described in these
directions for use and always hold it vertical to
the ground.
All other positions are dangerous. Check the
screws regularly to see that they are properly
tightened. Keep cables and other objects out of
the area you want to cut. If you have to lift the
grass trimmer to move it, switch off the motor and
wait for the rotating tool to stop. Before you
connect the grass trimmer to the power supply,
make sure that none of its moving parts are
damaged and that the line spool is correctly
inserted and fastened.
Never cut against hard objects when using the
grass trimmer. This is imperative to avoid causing
injury to the user and damage to the trimmer.
Use only original replacement parts for repair and
maintenance purposes. Have repairs carried out
only by a qualified electrician. Examine the grass
trimmer for signs of wear or damage each time
before you use it and after any collisions. Have
essential repairs carried out without delay.
Always keep your hands and feet away from the
cutting mechanism, particularly when you switch
on the trimmer. After pulling out new line, always
return the trimmer to normal working position
before you switch it on again. Never use
replacement parts or accessories which are not
foreseen or recommended by the manufacturer.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

34.112.11

Table des Matières