Command Mnemonics; Arguments; Setting The Extend Terminal Button Functions - Pioneer HD-V9000 Mode D'emploi

Command mnemonics

Command mnemonics consist of two-digit ASCII
alphabetic coded characters. Uppercase and lowercase
characters can be used without distinction.

Arguments

(1) Arguments are placed in front of the command.
If a command requiring an argument has no
argument, an error is generated.
(2) Arguments are of the following types:
1. Address:
The address consists of ASCII digit characters for the
frame number and time code, according to the
address mode.
The address mode is determined by the FR and TM
commands.
If a value greater than the maximum value is
attributed, the command will not work normally.
2. Argument:
The argument expresses a parameter for commands
with arguments other than the address (KL, GP, DS,
etc.).
The argument consists of ASCII alphabetic coded
characters and digit characters.
Setting the extend
terminal button
functions
"Extend Terminal" refers to the function for controlling
this unit by turning the switch of a device connected to
the EXT TERMINAL connector on the main unit's rear
panel on and off.
• SW1 to SW8 on the EXT TERMINAL connector on the
main unit's rear panel are pulled up to +3.3 V. Assign
functions to combinations of SW1 to SW8.
• For the pin layout, see page 64.
• A maximum of 56 switches can be connected by
combining SW1 to SW8.
• For the switch combinations and functions assigned
upon purchase, see page 69.
1 Display the Setup screen.
Press the SETUP button.
Select Initial Settings  Options  Extend
2
Terminal  User.
Use the /// buttons to select, then press the
ENTER button.
Initial Settings
Currrent (1-30)
01. 
LIST01
02. 
LIST02
03. 
LIST03
04. 
LIST04
05. ENTER LIST05
06. LIST01 LIST06
07. LIST02 LIST07
08. LIST03 LIST08
09. LIST04 LIST09
10. LIST05 LIST10
LIST11 PLAY
LIST12 PAUSE
LIST13 STOP
LIST14 STEP FWD
LIST15 STEP REV
LIST16 SCAN FWD
LIST17 SCAN REV
LIST18 NEXT
LIST19 PREV
LIST20 DISPLAY
09
67
En