Front Panel - Pioneer HD-V9000 Mode D'emploi

Front Panel

1 2 3
STANDBY/ON
1
Press to turn the power on and off (to the standby mode).
The indicator lights green when the power is on, orange
when the power is off (in the standby mode). The power
can be turned off (to the standby mode) forcibly by
pressing the button for 10 seconds while the power is on.
2 PHONES
Connect headphones here.
3 VOLUME (MAX, MIN)
Adjusts the volume of the sound output from the
headphones.
4 Door lock key
Locks the SD memory card insertion slot.
Locked
Groove is
horizontal
5 SD memory card insertion slot (page 37)
Press PUSH OPEN to open the door, then insert the SD
memory card. To close (or lock) the door, check that the
door lock key is unlocked.
Never eject the SD memory card or unplug the power
cord while the ACCESS indicator is flashing. Doing so
may destroy the data.
6 CARD ACCESS indicator
This flashes when the SD memory card is being read or
written.
7 Main unit display
The main unit display's backlight turns off automatically
if no operation is performed for three minutes, then lights
when an operation is performed.
4 5 6
Unlocked
Groove is
vertical
7 8 9 10 11 12
13 14 15 16
8 Remote control sensor
Point the remote control towards this sensor and operate
it within a range of about seven meters (23 ft.).
The unit may have trouble capturing remote control
signals if there is a fluorescent light nearby. If this
happens, move the unit away from the fluorescent light.
9 LAN indicator
This flashes when signals are being exchanged with a
device connected to the LAN port.
10 KEY LOCK indicator
This lights when the front panel's buttons are locked. The
indicator flashes if main unit buttons are operated while
they are locked.
11 IR LOCK indicator
This lights when remote control buttons are locked. The
indicator flashes if remote control buttons are operated
while they are locked.
12  – Press to start playback. When pressed during
playback, the pause mode is set. When the SETUP
indicator is lit, operates as the  button, moving the
cursor upward.
/ – Press to skip to the beginning of the
previous file. Press and hold to start reverse scanning
(page 40). When the SETUP indicator is lit, operates
as the  button, moving the cursor to the left.
/ – Press to skip to the beginning of the next
file. Press and hold to start forward scanning
(page 40). When the SETUP indicator is lit, operates
as the  button, moving the cursor to the right.
 – Press to stop playback. When the SETUP
indicator is lit, operates as the  button, moving the
cursor downward.
17 18 19 20
01
25
En