Connecting To A Display; Connecting To An Amplifier; Connecting The Video Out And Audio Out Terminals - Pioneer HD-V9000 Mode D'emploi

2 Attach the HDMI retaining cover to the HDMI
03
cable.
Mount the HDMI retaining cover so that it retains the
connector securely.
• Depending on the HDMI cable's connector size, the
gap and positional relationship between the HDMI
retaining cover and HDMI holder may differ.
3 Tighten the HDMI retaining cover's screw into
the HDMI screw hole to fasten the HDMI cable to this
unit.
Caution
• Do not tighten the screw with excessive force. Doing
so could damage the connector or cable.
• If the HDMI retaining cover is damaged, do not
continue using it. The cable could come loose or the
terminal could be damaged.
• The HDMI retaining cover is only designed to retain
the connector. This does not provide strength against
loads applied when the cable is pulled on, so be sure
to fasten the cable to the rack, etc.

Connecting to a display

When also connecting to an amplifier using the HDMI
cable, see Connecting to an amplifier (below).
Caution
• Hold the connector when connecting and
disconnecting cables.
• Applying excessive force to the connector could
result in faulty contact and prevent video signals from
being output.
Rear panel
L HDMI
DIGITA L
OUT
AU DIO
AU DIO OUT
Y
OUT
R
HDMI cable
(commercially
available)
To HDMI
input
32
En
COMPONENT
VIDEO OUT LAN(10/100)
VIDEO OUT
C B / P B C R / P R
NTSC ON
TV
75
SYSTEM
P AL OFF
EXT SYNC IN
Match the direction
of the plug to the
terminal and insert
the plug straight in.
It is also possible to connect this
unit to an amplifier using the
HDMI cable. (See below)
Direction of
signal flow
Display

Connecting to an amplifier

For instructions on connecting the amplifier and display
or the amplifier and speakers, see the amplifier's
operating instructions.
Caution
• Hold the connector when connecting and
disconnecting cables.
• Applying excessive force to the connector could
result in faulty contact and prevent video signals from
being output.
Rear panel
L HDMI
COMPONENT
DIGITA L
OUT VIDEO OUT
AU DIO
AU DIO OUT
Y C / P C / P VIDEO OUT
B B R R
OUT
R
HDMI cable
(commercially
To HDMI
available) input
terminal
Amplifier
From HDMI
output
HDMI cable
terminal
(commercially
available)
Connecting the
VIDEO OUT and
AUDIO OUT terminals
Connecting to a display
Rear panel
L
DIGITA L
AU DIO
OUT
RS-232C AU DIO
OUT
R
It is also possible to connect
to an amplifier. Use an audio
cable (2-channel) or coaxial
digital audio cable to
connect (see page 33).
To audio input terminal
To video input terminal
To component
video input
Display
terminals
Direction of signal flow
LAN(10/100)
NTSC ON
TV
75
SYSTEM
P AL OFF
EXT SYNC IN
Match the direction
of the plug to the
terminal and insert
the plug straight in.
Direction of signal flow
To HDMI input
terminal
Display
HDMI
COMPONENT
OUT
VIDEO OUT
Y C / P C / P VIDEO OUT
B B R R
NTSC ON
TV
75
SYSTEM
P AL OFF
EXT SYNC IN
Connect the VIDEO
OUT terminal or
COMPONENT VIDEO
OUT terminals. Use a
BNC cable with a
characteristic
impedance of 75 Ω.