Line Editing Commands - Pioneer HD-V9000 Mode D'emploi

 Frame Segment Play
Video files are played in units of frames.
Property Setting
Audio On
Off
Video On
Off
Audio Adjust –10 to 00
Lip Sync On
Off
Lip Sync Adjust –10 to 00 to
+16
Start Time ** h ** m ** s This sets the time for starting
End Time ** h ** m ** s This sets the time for stopping
1 *******
Search Frame
(7-digit
number)
1 *******
Mark Frame
(7-digit
number)
1. Set the interval between Search Frame and Mark Frame to at least
31 frames.
 Repeat List
Playback starts from the first line in the playlist.
• Set this at the very last line.
• When Repeat Mode is set to On, the list is played
repeatedly, regardless of this Repeat List setting
(page 47).
 Go to List
Playback starts from the first line in the playlist of the
specified number. Input the number using the number
buttons. Numbers 01 to 20 can be input.
• Set this at the very last line.
Note
• The time and number of frames changed at Property
is displayed in the Property contents display section.
Description
The audio is output.
The audio is not output.
The video is output.
The video is not output.
The volume is decreased by the
set dB value for output
The audio's delay time can be
fine-adjusted at Lip Sync
Adjust.
The audio's delay time is
adjusted automatically.
The video is displayed the set
number of frames before the
audio.
playback. Input the time using
the number buttons.
playback. Input the time using
the number buttons.
This specifies the starting point
for the range to be played, in
frames. Input the point using
the number buttons.
This specifies the end point for
the range to be played, in
frames. Input the point using
the number buttons.

Line editing commands

These are used to edit registered lines and add various
functions.
Caution
• The line editing commands cannot be edited once
registration of a line is completed.
 Insert File Play
This inserts a command to play video files in units of files.
The video file selected at File Select is played from the
beginning according to the Property settings. For details
on the contents of the Property settings, see File Play
under Type Select setting on page 58.
 Insert Frame Segment Play
This inserts a command to play video files in units of
frames. The video file selected at File Select is played
from the beginning of the frame specified at Property
settings. For details on the contents of the Property
settings, see Frame Segment Play under Type Select
setting on page 58.
 Add Image Overlay
This plays the specified still picture file superimposed
over the video file according to the settings below.
Property Selection
item
Black
Transparent
Color
White
Blue
Green
Yellow
Red
Transparent 0%
Rate
25%
50%
75%
Start Time ** h ** m ** s This sets the time for starting
Description
This sets black as the
transparent color for the
specified still picture file.
This sets white as the
transparent color for the
specified still picture file.
This sets blue as the
transparent color for the
specified still picture file.
This sets green as the
transparent color for the
specified still picture file.
This sets yellow as the
transparent color for the
specified still picture file.
This sets red as the transparent
color for the specified still
picture file.
The specified still picture file's
transparent color is not
transparent.
The specified still picture file's
transparent color is slightly
transparent.
The specified still picture file's
transparent color is half
transparent.
The specified still picture file's
transparent color is quite
transparent.
playback. Input the time using
the number buttons.
07
59
En