Connecting Usb Storage Devices; Connecting The Power Cord - Pioneer HD-V9000 Mode D'emploi

Connecting USB
03
storage devices
Caution
• Be sure to turn this unit's power off (to the standby
mode) before connecting or disconnecting USB
storage devices.
• When using an external HDD (hard disk drive) as the
external storage device, be sure to turn on the HDD's
power before turning on this unit's power.
• If the USB storage device is write-protected, be sure
to disable the write-protection.
• When connecting the USB cable, hold onto the plug,
set the plug in the proper direction for the port, then
insert it horizontally.
• Placing excessive loads on the plug may result in
faulty contact, making it impossible to read the data
on the USB storage device.
• Do not unplug the power cord when a USB storage
device is connected and this unit's power is turned
on.
Rear panel
USB
memory,
etc.
Note
• It is not possible to use the two USB ports
simultaneously.
• Devices may not work if connected to the USB port via
a memory card reader or USB hub.
• Use a USB cable with a length of two meters or less.
34
En
USB cable
(commercially
Hard disk
available)
drive, etc.
Connecting the power
cord
Connect the power cord after all the connections between
the devices have been completed.
Uninterruptible
power supply, etc.
Rear panel
AC IN
EXT TERMINAL
Power cable
(included)