Initial Use - Beurer MP 70 Mode D'emploi

6. Initial use

• Remove the packaging material.
• Make sure that all parts specified in the Included in delivery list
are contained (see 1. Included in delivery).
• Check the paraffin bath and mains cable for damage.
• Place the paraffin bath on a flat, secure, even and water-
resistant surface or table.
• Make sure that the paraffin bath is empty before filling it with
paraffin wax.
• Remove the paraffin wax from its plastic packaging.
• Put the desired amount of paraffin wax (minimum 0.9 kg,
maximum 1.35 kg) into the paraffin bath. In order to make it
easier to put the paraffin wax into the paraffin bath, break up
the blocks of paraffin wax.
Important
Make sure that the paraffin bath is always filled with paraffin wax
up to at least the MIN fill indicator line before use.
• Insert the mains plug into the socket (220-240V, ~50/60Hz).
The green operation light on the paraffin bath will light up.
The device is now switched on. The red heating light on the
paraffin bath will also light up, and will only go out when the
specified heat setting has been reached.
• Turn the temperature controller to "hot" to melt the paraffin
wax.
• Now place the lid on the paraffin bath and wait until the
paraffin wax has completely melted (around 2-3 hours).
Warning
If the paraffin bath is set to "hot", never dip your hands, feet or
elbows in the paraffin wax.
16