Accessories And Replacement Parts; What If There Are Problems; Disposal - Beurer MP 70 Mode D'emploi

• Then wipe the inside of the paraffin bath dry with a
clean towel.
Important
Never fill the paraffin bath with water in order to clean it.
• After cleaning, store the paraffin bath in a cool, dry and
dust-proof place.

9. Accessories and replacement parts

To purchase accessories and replacement parts, please visit www.beurer.com or contact the
corresponding service address (according to the service address list) in your country. Accessories
and replacement parts are also available from retailers.
Designation
2 x 450 g of paraffin wax + 30 plastic sleevers

10. What if there are problems?

Problem
The device is not
working
Heating lamp/ope-
ration lamp does
not light up
Hard wax in paraf-
fin bath
Discoloured paraffin
wax
The paraffin wax
takes longer to melt
than usual

11. Disposal

Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
Possible cause
No power supply
LEDs have reached the end of
their service life. LEDs faulty
The oil in the paraffin wax is used
up
May occur due to frequent use
A paraffin wax with a higher mel-
ting point is used
May occur due to frequent use
The paraffin wax is too cold
The device is not working
Item and/or order number
589.42
Solution
For repairs, please contact Customer
Services or an authorised retailer
Plug the mains adapter into the plug
socket
The mains adapter is faulty. Contact
Customer Services or your retailer.
For repairs, please contact Customer
Services or an authorised retailer
Renew the paraffin wax. Only use genui-
ne Beurer paraffin wax
Renew the paraffin wax. Only use genui-
ne Beurer paraffin wax
Store paraffin wax at room temperature
For repairs, please contact Customer
Services or an authorised retailer.
19