Usage - Beurer MP 70 Mode D'emploi

• As soon as the paraffin wax has completely melted, remove
the lid.
• Turn the temperature controller to the marked line between
"warm" and "hot".
• Lay the protective grille included in the delivery contents in the
liquid paraffin wax and wait until it has sunk to the bottom of
the paraffin bath.
• Put the lid back onto the paraffin bath and wait approximately
one hour, until the paraffin wax has cooled to an ideal
operating temperature (60°C).
Warning
The room temperature can affect the power of the device and
consequently the temperature of the wax.
Before submerging your hands, feet or elbows in the paraffin
bath, use the inside of your wrist to check that the temperature
of the wax is comfortable.
If a skin should form on the wax surface, increase the
temperature by turning the temperature controller clockwise. If
the paraffin wax is too hot for you, reduce the temperature by
turning the temperature controller anti-clockwise.

7. Usage

Warning
Before submerging your hands, feet or elbows in the paraffin bath, use the inside of your wrist to
check that the temperature of the wax is comfortable.
Warning
Take off your jewellery (e.g. watches, rings, etc.) before treatment.
After you have completed the necessary preparations from "Chapter 6 Initial use", you can begin
using the device. To start the treatment, carry out the following steps:
• We recommend applying a lanolin-based hand lotion to
the areas to be treated before treatment. This will help
you achieve a better result, and will make it easier to
remove the paraffin wax after treatment.
Warning
When using the paraffin bath on your feet, only use it sitting
down. Never stand in the paraffin bath.
• Briefly submerge the area to be treated (your hand, foot
or elbow) for 1-2 seconds in the liquid paraffin wax.
Remove your hand again and wait briefly until the wax
has solidified. During this time, do not move the treated
area, so that the wax can solidify properly.
17
1-2 s