Using A Xd-Picture Card; Selecting Images For Printing - Sony SnapLab UP-CR10L Mode D'emploi

Using a xD-Picture Card

Inserting the xD-Picture Card
With the v mark on the xD-Picture Card facing up and
forward, completely insert the xD-Picture Card into the
slot.
When you insert the xD-Picture Card into the unit, it is
automatically detected.
Removing the xD-Picture Card
When you see a message that prompts you to remove the
xD-Picture Card, first push the xD-Picture Card until you
hear a click, then pull it out.
Note
To prevent losing valuable data or damaging the xD-
Picture Card, never remove the xD-Picture Card from the
slot until the message prompts you to remove it.
32

Selecting Images for Printing

Selecting Images for
Printing
The procedure for selecting images from the inserted
memory card is described below.
This procedure can be carried out in any operation mode.
1
Touch any place on the screen.
The language selection screen appears.
Memo
When using Event mode, and when only one language
was selected at the administration screen, the language
selection screen does not appear. Instead, the Main
Menu appears. In this case, proceed to step 3.
2
Touch the language you want to use.
Precautions about using the unit are shown. Read these
carefully and then touch the [OK] button.