Sony SnapLab UP-CR10L Mode D'emploi page 12

When using the print pack 2UPC-C13 or
2UPC-C15
Remove the adaptors from the paper holder.
Note
Store the adaptors in a safe place so as not to lose them.
Loading the paper roll and ribbon
cartridge
When using the printer for the first time, you must first
load a paper roll and ribbon cartridge. When using the
2UPC-C14, adaptors must be installed in the paper holder,
as described in the section "Attaching adaptors to paper
holder" on page 11.
For information on how to remove a spent paper roll and
ribbon cartridge, see the section "Removing the paper roll
and ribbon cartridge" on page 15.
Notes
• Always use a designated print pack.
• Always replace the paper roll and ribbon cartridge
together as a set.
Loading the paper roll
1
Insert the paper core into the paper roll.
12
Installation
Notes
• If the edges of the paper roll are uneven, make sure
to even them out before installing the paper roll.
Otherwise a malfunction may occur.
• If the paper is wound loosely around the core, make
sure to wind it tightly before installing the paper roll.
Otherwise a malfunction may occur.
• Do not grasp the paper too tightly or strike it against
a hard object, because the paper may tear or crease,
effecting the print quality.
2
Open the front door.
3
Press the paper holder release button and pull the paper
holder out.