Sony SnapLab UP-CR10L Mode D'emploi page 15

Notes
• There is extra paper on the paper roll. When the ribbon
cartridge is finished, remove the remainder of the paper
roll and install a new ribbon cartridge and paper roll.
• Make sure to use a matching paper roll and ribbon
cartridge set. Using an unmatched combination will not
only prevent you from obtaining normal print results but
may cause a paper jam or a malfunction.
• Do not touch the printing surface of the paper roll or the
ink on the ribbon cartridge. Fingerprints and other
pollutants can lead to reduced print quality.
Removing the paper roll and ribbon
cartridge
Removing the paper roll
1
Open the front door.
2
Press the paper holder release button and pull the paper
holder out.
3
Remove any paper remnants from the paper holder.
4
Press the latch on top of the paper holder and open the
holder.
5
Remove the paper roll.
6
Pull out the paper core from the paper roll.
Note
You will need to reuse the paper core. Be careful not
to misplace it.
15
Installation