Connecting The Power Cables For The Ts 12Xx Models - Tectro TS 1225 Manuel D'installation

Outdoor unit:
To the indoor unit

11.2 Connecting the power cables for the TS 12xx models.

a. Connect the cable of the indoor unit first.
b. The connecting cable for the connection of the indoor unit with the outdoor unit has to be a type
H07RN-F, 2.5 mm² cable.
c. To connect the cable to the terminal block of the indoor unit: Remove the front panel and the cover
of the terminal block. The terminal block is located at the right side of the indoor unit. Picture 19.
Front panel
Picture 19
d. The cable can be guided to the terminal block via the rear of the indoor unit in the same way as the
already placed power cable.
e. Connect the wires to the terminal block. Refer to Fig. 20 for the correct position.
Picture 20
f. Now connect the cable of the outdoor unit. Remove the cover of the terminal block of the outdoor
unit.
g. Connect the connecting cable to the terminal block. See figure 21. Connect the wiring according the
position of the connected wires of the indoor unit (letters L N 1 and ground).
h. The grounding cable can be connected directly to the metal plate on which the terminal block is
mounted. The position is indicated by the symbol
i. Connect the power cable only when the entire installation of the air conditioner is completed.
Outdoor unit:
Secure the cable with a cable clamp
Cover plate
to the outdoor unit
Picture 18
.
4
87