Change Id Codes; Accessories - Petsafe SportDOG SportTrainer SD-1875E Manuel D'utilisation

STEP :: 11

CHANGE ID CODES

An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is
programmed in 1 of 2,000 ID Codes from the factory. The SportTrainer® SD-1875E has the flexibility to
program two or more Remote Transmitters to the same ID Code allowing them to both control one Collar
Receiver. There are 64 programmable ID Codes available.
TO MANUALLy PROGRAM A REMOTE TRANSMITTER'S ID CODE
1. Turn the Intensity Dial to V/T, flip the toggle switch to the up position, and then press and release the Mode
Button on the back of your Remote Transmitter. This does not change the mode, so the current mode will still
be active after the ID change is complete.
2. Once the Mode Button is released, the green Indicator Light will illuminate and stay on for 15 seconds.
3. While the green light is on, turn the Intensity Dial to select the 1st digit of the ID and then press and release
the Left-Side Button. The green light will flash rapidly confirming selection.
4. Again, while the green light is on, turn the Intensity Dial to select the 2nd digit of the ID and then press and
release the Left-Side Button. The green light will flash rapidly confirming selection. The 2nd digit is optional
and, if not desired, wait until the green light turns off and refrain from pressing the Left-Side Button.
5. At the end of 15 seconds, or after the second press of the Left-Side Button, the green light will turn off and
the ID of the unit will be updated. At this point, the unit will be in the same mode it was in prior to setting
the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver and Remote Beeper to the Remote
Transmitter (see STEP 7).
Note: If you press the Left-Side Button only once (skipping Step 4) the ID is still a two digit ID. The left digit is
defaulted to 1. For example, if you selected 6 in step 3 and pressed the Left-Side Button only once, the Programmed
ID will be 16.
TO RETURN THE UNIT TO THE FACTORy ID
1. Turn the Intensity Dial to V/T, flip the toggle switch to the up position, and then press and release the Mode
Button on the back of your Remote Transmitter. This does not change the mode, so the current mode will still
be active after the ID change is complete.
2. Once the Mode Button is released, the green Indicator Light will illuminate and stay on for 15 seconds.
3. Do not press any buttons and wait until the green Indicator Light turns off.
4. You will now need to match the Collar Receiver and Remote Beeper to the Remote Transmitter (see STEP 7).

ACCESSORIES

To purchase additional accessories for your SportDOG® brand SportTrainer® SD-1875E Remote Trainer
with Beeper, contact the Customer Care Centre or visit our website at www.sportdog.com to locate a retailer
near you.
WWW.sportdog.com 21