Change Run Mode; Locating Your Dog In The Field - Petsafe SportDOG SportTrainer SD-1875E Manuel D'utilisation

CHANGE RUN MODE

The Run Mode is changed using the Run Mode Button on the Remote Transmitter. You have three choices of
how often the beeper sounds when your dog is moving: Never (Silent Mode), every 5 seconds (5 Second Mode),
or every 10 seconds (10 Second Mode). In all modes, the Remote Beeper beeps once per second when the dog
stops moving.
1. Press and hold the Run Mode Button while viewing the back of the Remote Transmitter.
2. After 2 to 3 seconds, an indicator light next to the current Run Mode will light up.
3. Continue holding the Run Mode Button until the indicator light for the desired mode lights up.
4. Release the Run Mode Button. The Indicator Light next to the corresponding mode will flash several times
indicating the new Run Mode is set.
Note: If you would like different Run Modes for each dog in 3-Dog operation, follow the instructions below to
manually configure each of their Remote Beepers.

LOCATING yOUR DOG IN THE FIELD

Anytime your dog is within 1600 m, you can make the Remote Beeper beep by pressing the Locate Button
on the Remote Transmitter. The Remote Beeper will beep once each time you press the button. Pressing the
Locate Button disables the Remote Beeper's Run Mode, but Run Mode is still on. To reactivate the Run Mode,
press and release the Remote Transmitter's Run Mode Button. The Remote Beeper will emit 3 beeps to confirm
Run Mode has been activated and will continue operating in the last Run Mode in which it was set.
MANUALLy CONFIGURE THE REMOTE BEEPER
The Remote Beeper can be remotely programmed from the Remote Transmitter, or you can program tone and
Run Mode from the beeper itself.
1. Turn the Remote Beeper off.
2. Press and release the On/Off button to turn on the Remote Beeper.
3. Within 5 seconds press and hold the On/Off button. The Remote Beeper will begin to cycle through the 9
available tones.
4. When the desired tone is heard, release the On/Off button before the next tone starts. Tone is now set.
5. Press and hold the On/Off button immediately following tone selection completion until the number of beeps
matches the desired Run Mode as shown in the chart.
1 Beep (Silent Mode)
2 Beeps (5 Second Mode)
3 Beeps (10 Second Mode)
6. Release the On/Off button after the corresponding number of beeps matches your desired Run Mode.
No beep when dog is running/Beeps once per second when dog is
on point
Beeps every 5 seconds when dog is running/Beeps once per second
when dog is on point
Beeps every 10 seconds when dog is running/Beeps once per second
when dog is on point
WWW.sportdog.com 19