Program The System For Two-Dog Operation; Program The System For Three-Dog Operation - Petsafe SportDOG SportTrainer SD-1875E Manuel D'utilisation

STEP :: 09
PROGRAM THE SySTEM FOR TWO-DOG
OPERATION
SportDOG® Collar Receivers and Remote Beepers can be set to respond to either the up or down toggle
switch position. A SportDOG® Add-A-Dog® Extra Collar Receiver with Remote Beeper must be purchased to
train and locate a second dog in two-dog mode. Please refer to the back cover for the compatible
Add-A-Dog® Collar Receiver with Remote Beeper for this system.
1. Program the Remote Transmitter to modes 1 – 6 in either the Toggle Switch
up or Toggle Switch down position (see STEP 6).
2. Flip the toggle switch to the up position.
3. Program the first Collar Receiver and Remote Beeper:
A. Turn the Collar Receiver and Remote Beeper off.
B. Press and hold the On/Off Button for each. The Collar Receiver and Remote
Beeper Indicator Lights will come on, then turn off in 4-5 seconds. If
the On/Off Button is released too early, the Collar Receiver and Remote
Beeper Indicator Lights will begin their normal flashing. If this occurs, start
over from A.
C. After the Collar Receiver and Remote Beeper Indicator Lights have turned
off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Collar Receiver and Remote Beeper
Indicator Lights flash 5 times. If the Collar Receiver and Remote Beeper Indicator Lights do not flash 5
times, start over from A.
4. Program the second Collar Receiver and Remote Beeper the same way using A through D above, but with
the toggle switch in the down position.
STEP :: 10
PROGRAM THE SySTEM FOR THREE-DOG
OPERATION
SportDOG® Add-A-Dog® Collar Receivers with Remote Beepers must be purchased to train and locate
additional dogs. Please refer to the back cover for the compatible Add-A-Dog® Collar Receiver
with Remote Beeper for this system.
1. Program the Remote Transmitter to mode 5 in either the Toggle Switch up or the Toggle Switch down
position (see STEP 6).
2. Flip the toggle switch to the up position.
3. Program the first Collar Receiver and Remote Beeper:
A. Turn the Collar Receiver and Remote Beeper off.
B. Press and hold the On/Off Button for each. The Collar Receiver and Remote Beeper Indicator Lights will
come on, then turn off in 4-5 seconds. If the On/Off Button is released too early, the Collar Receiver and
Remote Beeper Indicator Lights will begin their normal flashing. If this occurs, start over from A.
C. After the Collar Receiver and Remote Beeper Indicator Lights have turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Collar Receiver and Remote
Beeper Indicator Lights flash 5 times. If the Collar Receiver and Remote Beeper Indicator Lights do not
flash 5 times, start over from A.
4. Program the second Collar Receiver and Remote Beeper using A through D above, but using the
Lower Button in place of the Upper Button.
5. Program the third Collar Receiver and Remote Beeper using A through D above, but using the
Left-Side Button in place of the Upper Button.
20 WWW.sportdog.com
TOGGLE SET TO UP FOR DOG
1 OR TOGGLE SET TO DOWN
FOR DOG 2