Fit The Collar Receiver And Remote Beeper - Petsafe SportDOG SportTrainer SD-1875E Manuel D'utilisation

STEP :: 04

FIT THE COLLAR RECEIVER AND REMOTE BEEPER

IMPORTANT: The proper fit and placement of the Collar Receiver is important for effective training. The
Contact Points must have direct contact with your dog's skin.
Please see page 3 for Important Safety Information.
This system is designed so you can add or remove the Remote Beeper to or from the Collar Receiver strap as
needed. The Remote Beeper can also be used on the collar strap without the Collar Receiver.
To ensure a proper fit, follow these steps:
1. Thread the end of the collar strap through the slot in the Remote Beeper
and then through the slot on the opposite side of the Remote Beeper.
Slide the Remote Beeper up the collar strap. The knob located on the
bottom of the Remote Beeper can be placed in one of the collar strap
holes to prevent sliding and to ensure it remains properly in place.
2. With your dog standing (4A), center the Collar Receiver so the Contact
Points are underneath your dog's neck, touching the skin (4B), and the
Remote Beeper is centered behind the dog's head. If your dog has a
long or thick coat, you have two options to ensure consistent contact:
either trim the hair around the Contact Points or switch to the longer
Contact Points included with your system.
• You may need to trim the hair in the area of the Contact Points. Never shave the dog's neck; this may lead
to a rash or infection.
• You should not make the collar any tighter than is required for good contact. A collar that is too tight will
increase the risk of pressure necrosis in the contact area.
3. The Collar Receiver should fit snugly, yet loose enough to allow one finger to fit
between the strap and your dog's neck (4C).
4. Allow your dog to wear the collar for several minutes and then recheck the
fit. Check the fit again as your dog becomes more comfortable wearing the
Collar Receiver.
12 WWW.sportdog.com
4A
4B
4C