EUROM CWC9000B Manuel D'utilisation page 18

Operation
Insert the plug into the socket. The unit is now ready for use.
- Start the unit by pressing the ON/OFF button. Pressing it again will stop the unit.
- Pressing on the Speed button allows you to choose a ventilation speed; you select a
different speed each time you press: L (low) – M (medium) – H (high). The corresponding
light will then come on.
- Pressing on the Mode button allows you to select a method of ventilation; you can set the
speed using the 'speed' button.

Normal – gives a regular breeze

Natural – gives a natural, irregular breeze

Sleep – gives a natural, irregular breeze that switches to low speed, irrespective
of the fan speed setting, after half an hour.
- The Swing button makes the breeze swivel from left to right horizontally; the
corresponding light will come on. Pressing it again switches this function off. By adjusting
the horizontal panels manually, you can adjust the vertical outlet direction.
- Pressing the Humidify button when the unit is on will switch on the
humidification function; the corresponding light will then come on.
Pressing it again switches this function off.
- Pressing the Ion button will switch the anion generator on; the
corresponding light will come on. Pressing it again switches this function
off.
- Pressing the Timer allows you to set the required time: each press on
the button gives a further half hour, until max. 7.5 hours. Pressing it
again switches this function off. The lights indicate the set time.
Remote control
Install 2 AAA batteries in the section at the back of the remote control. You
can now operate the unit from a distance of max. 6 metres. The buttons on
the remote control correspond with those on the operating panel. The
receiver is positioned on the top left hand side of the operating panel;
always point the remote control in this direction.
Remove the batteries if the device is not going to be used for some time.
Cleaning and Maintenance
Switch off the equipment and remove the plug from the socket before cleaning or carrying
out maintenance work.

Wipe the outside of the equipment regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!
Ensure that the operating panel does not get wet.

Use a vacuum cleaner to carefully remove any dust and dirt from the grills and ensure
that the air intake and outlet openings are clean. Be careful not to touch or damage any
internal parts during cleaning!
18