Ingeteam INGECON SUN STORAGE 1Play Série Manuel D'installation page 63

Masquer les pouces Voir aussi pour INGECON SUN STORAGE 1Play Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 155
Safety
Carry out all operations and handling without voltage.
As a minimum security measure in this operation, you must always follow the so-called 5 golden rules:
1.
Disconnect.
2.
Prevent any possible feedback.
3.
Check there is no voltage.
4.
Ground and short circuit.
5.
Protect from live elements, if any, and put up safety signs around the work zone.
Until these five steps are completed, the work area cannot be considered voltage-free and any work
performed will be considered to be work on live equipment.
The space for the installation of the storage system must be properly ventilated.
The storage system must be installed in such a way that any accidental short-circuits are avoidable.
Potential hazards for people
Bear in mind the following warnings concerning personal safety.
DANGER: Electric Shock.
The equipment may remain charged after disconnecting the renewable power supply and grid power.
Carefully follow the mandatory steps in the manual for removing the voltage.
DANGER: Explosion.
There is a very low risk of explosion in very specific cases of malfunction.
The casing will protect people and property from the explosion only if it is correctly closed.
DANGER: Crushing and joint injuries.
Always follow the indications in the manual on moving and placing the unit.
The weight of this unit can cause injury if not handled correctly.
DANGER: High temperature.
The flow of outlet air can reach high temperatures which can cause injury to anybody exposed to it.
Potential hazards for the equipment
Bear in mind the following warnings concerning protection of the equipment.
CAUTION: Cooling.
The unit requires impurity-free air flow while it is operating.
Keeping the unit in the upright position and the inlets free of obstacles is essential for this air flow to
reach the inside.
CAUTION: Connections.
After all duly authorized handling, check that the inverter is ready to start operation. Only after this
can it be connected following the instructions in the manual.
ABH2013IQM01_A - Installation and Operation Manual
Ingeteam
DE
EN
ES
FR
IT
PT
63

Publicité

Table des Matières
loading

Table des Matières