Residual Current Device; Description Of Wiring Inlets - Ingeteam INGECON SUN STORAGE 1Play Série Manuel D'installation

Unit description
Public grid connection regulations
The maximum power of the inverter is a calculation of the battery voltage multiplied by the maximum discharge current (50 A).
(1)
is no PV energy. Never exceed this value. Consider the voltage increase of the panels 'Voc' at low temperatures.
(3)
battery voltage multiplied by the maximum discharge current reaches said value.
16 A.

2.6. Residual current device

The units without a transformer (TL) incorporate a differential circuit breaker which serves to disconnect the unit in
the event of a 30mA differential current.
This residual current device exclusively protects the unit. You must install a residual current device to
protect the installation according to the country's legislation.

2.7. Description of wiring inlets

Units without a transformer
D
A
G
B
C
Units with a transformer
D
A
G
B
C
ABH2013IQM01_A - Installation and Operation Manual
3
RD1699/2011, DIN V VDE V 0126-1-1, EN 50438, CEI 0-21, VDE-AR-N 4105:2011-08,
G59/2, G83/2 , AS4777.2, AS4777.3, IEC 62116, IEC 61727, UNE 206007-1, ABNT
(6)
NBR 16149, ABNT NBR 16150, South African Grid code, IEEE 929Thailand MEA & PEA
E F
I J
F H
E F
I J
F H
K
3TL 6
requirements
This power will be available if the
(4)
(5) This parameter can be set on the display.
A. Storage system (PG20).
B. PV array *.
C. DC switch *.
D. Communications accessories
(PG20).
E. CAN communication of the
storage system management system
(PG16).
F. Digital inputs / outputs (PG16).
G. Storage system temperature
sensor PT-100 (PG16).
H. Synchronization input for three-
phase systems (PG16).
K
I. Consumption grid (PG25).
J. Auxiliary grid/genset (PG25).
K. Transformer connection **.
* Optional.
** Units with a transformer.
Ingeteam
6TL
DE
EN
Only possible if there
(2)
ES
(6) For units of more than
FR
IT
PT
61