Maintenance / Servicing; Repairs / Overhaul; Disposal / Recycling - Eaton CROUSE-HINDS Série Mode D'emploi

7

Maintenance / Servicing

The relevant national regulations which apply to the mainte-
nance/servicing of electrical apparatus, shall be observed.
Before opening the enclosure make sure that the apparatus is
disconnected from the supply, or take the appropriate protective
measures.
The required maintenance intervals depend on the respective application
and shall therefore be determined by the user dependent on the
conditions of use�
When servicing the apparatus, particularly those parts that are decisive for
the type of protection against explosion, shall be checked (e� g� intactness
of the enclosure, cable glands, efficacy of the gaskets)�
The reliable working of the cover lock and the integrity of the
padlocking device shall be especially checked.
If during servicing repairs prove to be necessary, section 8 of these
operating instructions shall be observed�
8

Repairs / Overhaul

Repairs may only be carried out with genuine Cooper Crouse-Hinds /
CEAG spare parts�
Repairs may only be carried out by Cooper Crouse-Hinds / CEAG
or a qualified electrician in compliance with the respective national
regulations.
In case the switch base is damaged, only its replacement will be
permitted. In case of doubt, the respective apparatus will have to be
returned for repair to Cooper Crouse-Hinds / CEAG.
Modifications to the apparatus or changes of its design are not permitted,
except for the mounting of additional cable entries in accordance with the
approval of the apparatus�
9

Disposal / Recycling

When the apparatus is disposed of, the respective national regulations on
waste disposal will have to be observed�
In case of disposal you can obtain additional information from your Cooper
Crouse-Hinds /
EATON branch�
Subject to modifications or supplement of the product range�
22
Switches, GHG 981,
industrial design up to 250 A, 3 and 6-pole
GB