Care And Maintenance - Beurer FT 65 Mode D'emploi

Surface temperatures:
1. Switch the thermometer on and then press and hold the M
symbol will appear in the LCD Display indicating the thermometer is in Object Temperature Mode.
2. Hold the sensor 2-3 cm (1-1 ½ inches) from the object to be measured and press and hold the Power Button
about a second, release the Power Button
3. Shut the thermometer off to exit Object Temperature Mode.
Viewing Stored Measurements
This device stores 10 measurements, along with the date/time and measurement mode for each. With the device switched
on, press the M Button
measurements.

7. Care and Maintenance

• The sensor is the most sensitive part of the thermometer. Work carefully when cleaning the sensor to avoid product
damage. Use a clean cloth or cotton swab moistened with disinfectant, alcohol, or warm water.
• To clean the outer surface of the thermometer, use a soft cloth slightly moistened with a mild soapy solution.
• Do not use any harsh cleaning products.
• Before prolonged storage, remove the batteries.
• Do not use or store the device in excessively high or low temperature or humidity, in direct sunlight, near an electrical
current or in dusty locations.
• Always store the thermometer with the sensor cover on.
• Never immerse the device in water.
• To protect the sensor tip, always replace sensor cover after use.
• To clean the device, use a soft, damp cloth and a mild detergent. Ensure water does not get into the device. If the device
does get wet, remove the battery immediately and let dry completely before reuse.
; the thermometer will beep once and display the measurement.
to display the last measurement. Press the M Button
and Power Buttons for about three seconds; the
12
repeatedly to cycle through the older
. After