Using The Product - Ryobi RM480e Traduction Des Instructions Originales

WARNING
Hold the deck height adjustment lever fi rmly
when setting the deck height and release
only when it is secure in the desired slot.
Quickly letting go of the lever may create a
pinching or pulling hazard to the operator's
hand.
Deck height adjustment lever
SETTING THE CRUISE CONTROL
See fig. 16
Cruise control allows the product to remain at
a constant speed without the operator having
to maintain pressure on the accelerator pedal.
It should only be used in the forward position
on relatively smooth, straight surfaces, and
should never be used on slopes or rough
terrain.
To set the cruise control:
While driving the product forward, press the
accelerator pedal until the desired rate of
speed is achieved.
1. Press the cruise control button. The light
around the button illuminates to indicate
that cruise control is active.
2. Release pressure on the accelerator
pedal. Mower speed should remain
constant.
To release the cruise control:
1. Tap on the accelerator pedal.
2. Release the brake pedal, or press the
cruise control button again. The light
around the cruise control button goes
out to indicate to that cruise control is no
longer active.
24 | English
Cruise control
button

USING THE PRODUCT

See fig. 17 - 18
Clear the area of bystanders before
Fig 15
operating the product. If anyone enters the
mowing area, stop immediately and do not
return to mowing until the bystanders leave
the area.
Before starting the product:
■ Ensure that the work area is clear of
children, bystanders, and pets.
■ Clear the work area of objects that may be
thrown by the mower blades.
■ Check the brake operation.
■ Check the tyre pressure.
■ Check for loose fasteners.
■ Make sure that all guards are in place and
working properly.
■ Clean debris from mower.
■ Check the side discharge chute safety
interlock system
■ Test the operator presence safety interlock
system.
■ Adjust the seat to the preferred position.
■ Verify the battery charge level.
Fig 16
WARNING