Required Tools - Ryobi RM480e Traduction Des Instructions Originales

To reduce the risk of injury, read and understand the assembly section of this manual before
attempting to assemble the product. Save this guide for future reference.
ASSEMBLY SAFETY RULES
WARNING
Strictly adhere to all torque wrench
tightening specifi cations. Failure to do so
could cause serious personal injury.
All information, illustrations, photographs,
and specifi cations contained in this manual
are based on the latest product information
available at the time of publication. Due to
improvements or other changes, there may
be some discrepancies in this manual. We
reserve the right to make product changes at
any time, without notice and without incurring
any obligation to make the same or similar
changes to any products previously built or
sold.
■ Any person attempting to assemble the
product must have proper training and
experience. Read this manual carefully
and follow all assembly procedures in this
manual.
■ All assembly must be completed with the
product on a level surface.

REQUIRED TOOLS

The following tools are needed for assembly:
■ Torque wrench
■ Tyre pressure gauge
■ Socket wrench
● 12 mm socket
● 13 mm socket
● 6 mm hex bit
12 | English
ASSEMBLY
WARNING
UNPACKING
See fig. 1
■ Remove the bolts securing the corner and
side braces to the frame bottom, then lift
the braces to remove.
■ Cut the nylon straps securing the front and
rear wheel axles to the frame.
■ Remove the boxes containing loose parts,
assembly hardware, and documentation.
■ Remove and set aside all accessible
packaging and wrap from the unit and
parts. Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the product.
If any parts on the "Loose parts list" section
are already assembled to the product
when you unpack it, verify that the part is
assembled correctly, is properly tightened,
and is torqued correctly (where applicable)
before proceeding to the next assembly
step. Use of a product that may have
been improperly assembled could result in
serious personal injury.
■ Inspect the product carefully to ensure that
no breakage or damage occurred during
shipping.
■ If any parts are damaged or missing,
contact an authorised service centre.
NOTE: The product should be assembled
while positioned on the frame bottom.
Once assembly is complete, set the cutting
deck to its maximum height, then position a
ramp next to the frame bottom, and slowly
and carefully drive the product off the
frame.
WARNING