Replacing The Airclean Filter; Replacing The Airclean Plus 50, Silence Airclean 50, Active Airclean 50 And; Replacing One Type Of Exhaust Filter With Another - Miele Complete C3 SG Série Mode D'emploi

Replace these filters when the
timestrip® filter change indicator is
completely red (dia. 13). The indicator
lights up after approximately 50 hours
of operation, which is equivalent to
about a year of average use. You can
continue vacuuming when the light
comes on. However, the suction power
will be reduced as will the effectiveness
of the filter if it is not replaced in good
time.
Replacing the AirClean
filter (dia. 41 + 42)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Press the release catch on the filter
grille and open the grille until it clicks.
 Grasp the used AirClean filter by one
of the clean, unsoiled sections and
take it out.
 Replace it with a new AirClean ex-
haust filter.
If you wish to fit an AirClean Plus 50,
Silence AirClean 50, Active AirClean
50 or HEPA AirClean 50 filter, see the
"Replacing one type of exhaust filter
with another" section.
 Close the filter grille.
 Close the dust compartment lid.
Replacing the AirClean Plus 50,
Silence AirClean 50, Active AirClean
50 and HEPA AirClean 50 exhaust fil-
ters (dia. 43 + 44)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position.
 If you are using exhaust filter c, d or
e, you must also activate the
timestrip® filter change indicator (dia.
11).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (dia. 12).
If you wish to fit an AirClean filter,
see the "Replacing one type of ex-
haust filter with another" section.
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 08)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Silence AirClean 50 (grey)
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c, d or e it is essential
that you remove the filter grille before
you fit the new exhaust filter.
en
57