Bosch IXO Notice Originale page 31

LED
Slowly flashing light 1 x green
Slowly flashing light 2 x green
Slowly flashing light 3 x green
Continuous light 3 x green
During the charging process, the handle of the power tool will heat up. This
is normal. If you are not planning to use the power tool again soon, discon-
nect the charger from the mains. The power tool cannot be used during the
charging process. It is not defective if it does not work during the charging
process. Follow the instructions on correct disposal.
Protect the charger against moisture.
u
The battery charge indicator shuts down after 30 seconds if the power tool is not run-
ning.
Changing the tool (see figure B)
Do not use two-sided screwdriver bits that are longer than 25 mm.
u
Insert the screwdriver bit (1) directly into the tool holder (2).
Off-Set Angle Adapter/Angle Screw Adapter (see figures C –
F)
Note: The power tool is not intended for use with the grass shears attach-
ment (1 600 A00 10D).
You can drive in screws close to edges using the off-set angle adapter (14).
The angle screw adapter (15) allows you to drive in screws in hard-to-reach
areas.
Assembly (see figures C – D)
To fit the adapters, pull off the rubber cap (3) towards you. Then the ad-
apters can be attached. The attachments can be mounted offset by 45° re-
spectively.
Removal (see figures E – F)
To remove the attachments, turn the unlocking ring (16) in the rotational
direction ➊ and pull the adapter off towards you. Then reattach the rubber
cap (3).
Bosch Power Tools
English | 31
Capacity
0 – 30 %
30 – 60 %
60 – 100 %
100 %
1 609 92A 4MH | (29.05.2019)