Bosch IXO Notice Originale page 30

30 | English
Assembly
Battery Charging (see figure A)
Use only the chargers listed in the technical data. Only these chargers
u
are matched to the lithium-ion battery of your power tool.
Note the mains voltage! The voltage of the power source must match
u
the voltage specified on the rating plate of the charger. Chargers marked
with 230 V can also be operated with 220 V.
Note: The battery is supplied partially charged. To ensure full battery capa-
city, fully charge the battery in the charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the "Elec-
tronic Cell Protection (ECP)". When the battery is discharged, the power
tool is switched off by means of a protective circuit: The application tool no
longer rotates.
Do not continue to press the On/Off switch after the power tool has
u
automatically switched off. The battery can be damaged.
Battery charge indicator during operation
The battery charge indicator (4) displays the state of charge of the battery
when the power tool is switched on.
LED
Continuous light 3 x green
Continuous light 2 x green
Continuous light 1 x green
Flashing light 3 x green
The battery charge indicator shuts down after 30 seconds if the power tool is not run-
ning.
To charge the battery, plug the charging cable (12) into the port on the bot-
tom of the handle and into the charger (13). Then plug the mains cable of
the charger (13) into the mains socket.
Battery charge indicator during charging
The battery charge indicator (4) indicates the charging progress. During the
charging procedure, the indicator flashes.
1 609 92A 4MH | (29.05.2019)
Capacity
60 – 100 %
30 – 60 %
10 – 30 %
0 – 10 %
Bosch Power Tools