Starting Operation - Bosch IXO Notice Originale

32 | English
Operation

Starting Operation

Setting the rotational direction
The rotational direction switch (5) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (8) is
being pressed.
Do not use the rotational direction switch (5) when the power tool is
u
in operation, as this may damage it.
Clockwise rotation: To drive in screws, slide the rotational direction switch
(5) forward to the stop.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
Switching on/off
To start the power tool, press and hold the on/off switch (8).
The worklight (9) lights up when the on/off switch (8) is lightly or fully
pressed, allowing the work area to be illuminated in poor lighting conditions.
To switch off the power tool, release the on/off switch (8).
Adjusting the Speed
You can adjust the speed of the power tool by pressing in the on/off
switch (8) to varying extents.
A light pressure on the on/off switch (8) results in a low rotational speed. In-
creased pressure on the switch causes an increase in speed.
Fully automatic spindle lock (Auto-Lock)
The drill spindle, and therefore the tool holder, are locked when the on/off
switch (8) is not pressed.
This allows screws to be driven in even when the battery is discharged and
enables the power tool to be used as a screwdriver.
If the drill spindle is blocked, do not press the on/off switch (8) for
u
longer than 15 seconds. Otherwise, the power tool may become dam-
aged.
1 609 92A 4MH | (29.05.2019) Bosch Power Tools