Dometic Waeco CombiPower 2012 Instructions De Montage page 63

_CombiPower_IA_DE-IT.book Seite 63 Freitag, 21. Oktober 2011 8:10 20
CombiPower
NOTICE!
A
 Check that the voltage specification on the type plate is the
same as that of the power supply.
 Ensure that other objects cannot cause a short circuit at the
contacts of the device.
 Ensure that the red and black terminals never come into
contact.
 Never pull the plug out of the socket by the cable.
2.2 Safety when installing the device
DANGER! Danger of electrocution
D
 For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
 Do not touch exposed cables with your bare hands. This espe-
cially applies to all cables in the AC mains circuit.
 If you are working on electrical systems, ensure that there is
somebody close at hand who can help you in emergencies.
 Never mount the device anywhere where there is a risk of gas
or dust explosion.
WARNING!
!
 Only install the device in closed, well-ventilated rooms.
 Never install the device in rooms where materials that are fire
hazards are stored, or where combustible gas is present; the
surface temperature can reach 60 °C.
 Do not operate the device in systems with lead acid batteries.
These batteries give off explosive hydrogen gas that can be
ignited by sparks on electrical connections.
 Before starting the device, ensure that the power supply line
and the plug are dry.
EN
General safety instructions
63