Making Pasta - Unold 68801 Notice D'utilisation

The two recesses and the bottom
holes in the mixing unit must cor-
respond exactly with the motor
block (Fig. 7).
12. Hold the lid upright on the mixing
container and make sure that the
two projections on the lid fit into
the recesses on the front side of
the motor block. Press the lid
down until it locks into place on
the mixing container (Fig. 8).
13. Important: The sealing cover must
audibly lock into place, since this
activates the safety switch; other-
wise, the appliance cannot be
switched on. In case the cover
does not lock into place, check
whether the mixing container was
inserted correctly.
14. Now insert the desired pasta ext-
ruder disc in the sealing ring.
Turn the sealing ring clockwise
onto the threads of the front cover
until it is tight (Fig. 9). Tighten
the sealing ring only by hand. You
can use the included wrench to
loosen the ring.
15. To disassemble the appliance,
perform the above steps in reverse
sequence.

MAKING PASTA

1. Before assembling the appliance,
make sure that it is not plugged
into the electrical outlet and that
both switches are set to OFF.
2. Place the appliance on a solid,
level and dry surface.
3. Remove the lid from the mixing
container by pulling the two pro-
Copyright UNOLD AG | www.unold.de
jections slightly forward and then
upward (Fig. 10).
Fig. 7
Fig. 8
Fig. 9
Fig. 10
27