Unold 68801 Notice D'utilisation page 26

4. Push the feed screw axle through
the front cover so that the feed
screw is within the front cover
(Fig. 2).
5. Fasten the kneader to the axle.
The feed screw axle is provided
with a notch, which must align
with the corresponding guide rail
in the kneader. (Fig. 3).
6. Place the kneader cover on the
axle. Here again, the notch must
align with
guide rail. The flat side of the
kneader cover must point to the
back (Fig. 4).
7. Push the entire feed screw axle
assembly through the front cover
of the mixing container. The
threads must point toward the
outside (Fig. 5).
8. Lock the front cover of the mixing
container. The symbol  must
align with the arrow on the mixing
container. Then turn clockwise
until the arrow aligns with the
symbol  (Fig. 6).
9. Important: The front cover must
be correctly locked and secured
before you continue assembling the
appliance. If the lid is already on
the mixing container, the front cover
cannot be locked.
10. Then push the entire front unit
onto the motor block.
11. The axle of the mixing unit must
be inserted into the hole on the
front side of the motor block.
26
the corresponding
Copyright UNOLD AG | www.unold.de
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6