Ryobi RY803111 Manuel D'utilisation page 16

TO REMOVE BATTERY PACK
See Figure 11.
 Open the battery cover.
 Depress the latches on each side of the battery pack.
 Remove the battery pack.
 Close the battery cover.
STARTING AND STOPPING THE PRESSURE
WASHER
See Figures 12 - 17.
NOTICE:
Do not run the pressure washer without water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure the
hose is not being restricted by tires, rocks, or any other
objects that may lessen or prevent water flow to the
pressure washer.
Before starting the engine:
 Install battery pack and close battery cover.
 Connect all hoses and cables.
NOTE: Make sure the pressure washer's water intake
screen is in place and unclogged before connecting
garden hose.
 Check all fluids (lubricant and gas).
 Turn on the garden hose then squeeze the trigger to relieve
air pressure; hold the trigger until a steady stream of water
appears.
NOTE: Make sure the faucet is turned on fully and that
there are no kinks or leaks in the hose.
To start the engine:
 Turn the fuel valve to the OPEN position.
 Push the choke in to the START position.
NOTE: If engine is warm or the temperature is above 50˚F,
pull the choke out until it clicks into the RUN position.
 Push in at the top of the engine switch to put it in the ON
position.
 Slide down and hold the lock button while pushing the
engine switch to the START position.
NOTE: A sufficiently charged RYOBI
pack must be installed before the pressure washer can
be started using only the engine switch.
 The pressure washer can also be started by pulling the
starter grip and rope until the engine runs.
NOTE: Do not allow the starter grip and rope to snap back
after starting; return it gently to its original place.
OPERATION
NOTICE:
If the starter grip and rope becomes difficult to pull,
squeeze the trigger to relieve water pressure before at-
tempting to start the engine again.
 Allow the engine to run for 5 seconds, then pull the choke
out until it clicks into the RUN position.
NOTICE:
Routinely make a visual inspection of the pump and
engine during use. If you notice any lubricant leaking
around the pump or engine seals, stop using the pres-
sure washer immediately. Contact customer service or a
qualified service center for repair. Failure to do so may
cause property damage.
To stop the engine:
 Put the engine switch in the OFF position by pushing in
at the bottom of the switch.
 Turn the fuel valve to the CLOSED position.
NOTE: Shutting off the engine will not relieve pressure in the
system. Pull trigger to release water pressure.
While operating and storing, keep at least 3 feet of
clearance on all sides of this product, including overhead.
Allow a minimum of 30 minutes of "cool down" time
before storage. Keep all body parts, clothing, combustible
materials, and hoses away from the muffler. Heat created
by muffler and exhaust gases could be hot enough to
cause serious burns, ignite combustible objects, and/or
damage high pressure hoses that can result in an injection
injury.
USING THE TRIGGER HANDLE
See Figure 18.
Hold the trigger handle securely with both hands. Expect
the trigger handle to move when the trigger is pulled due
to reaction forces. Failure to do so could cause loss of
control and injury to yourself and others.
One+ battery
™
™
 Pull back and hold the trigger to operate the pressure
washer.
 Release the trigger to stop the flow of water through the
nozzle.
To engage the lock out:
 Push up on the lock out until it clicks into the slot.
To disengage the lock out:
 Push the lock out down and into its original position.
Page 12 — English
WARNING:
WARNING: