Set Brightness Of Display; Using The Emergency Switch (Where Fitted); Usb Port For Power Supply - Dometic CoolFreeze CFX Série Notice D'utilisation

CFX28 – CFX65DZ
7.8

Set brightness of display

The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 4, page 3) four times.
➤ Use the "UP +" (fig. 3 7, page 3) or "DOWN –" (fig. 3 6, page 3) buttons to
set the brightness of the display.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The display shows the set mode for some seconds. The display flashes several
times before it returns to the current brightness.
I
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically is d0 (default). After
troubleshooting the set brightness is reactivated.
7.9

Using the emergency switch (where fitted)

The emergency switch (fig. 4 3, page 3) is located below the control panel on all
models except CFX28 where it is located above the power inlet sockets. For normal
operation the switch is in the "NORMAL USE" position.
➤ If an electronic control failure occurs, slide the switch to "EMERGENCY
OVERRIDE" position
I
NOTE
If the switch is in the "EMERGENCY OVERRIDE" position, the cooler runs
with full cooling capacity and may freeze.
7.10

USB port for power supply

USB port allows you to charge small devices like mobile phones and mp3-players.
To use your cooling box with any USB devices, simply connect a USB cable (not
included) to your device.
I
NOTE
Ensure that any small device connected to the USB port is compatible
with 5 V/500 mA operation.
EN
Operation
21