Setting The Temperature - Dometic CoolFreeze CFX Série Notice D'utilisation

CFX28 – CFX65DZ
I
NOTE
Displayed temperature
• CFX28, CFX35W, CFX40W, CFX50W, CFX65W:
The temperature displayed is that of the large interior compartment
(e.g. CFX50W, CFX65W: fig. 7 1, page 4).
• CFX65DZ:
– With fridge/freezer divider in: The temperature displayed is that
of the freezer compartment (fig. 8 1, page 5).
– With fridge/freezer divider out: The actual compartment
temperature will be considerably warmer than the displayed
temperature
✓ The cooler starts cooling the interior.
I
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2 1, page 2) down, until it latches in place audibly.
I
NOTE – Alarm "Lid open"
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
7.6

Setting the temperature

➤ Press the "SET" button (fig. 3 4, page 3) once.
➤ Use the "UP +" (fig. 3 7, page 3) and "DOWN –" (fig. 3 6, page 3) buttons to
select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
I
NOTE
The temperature can be set to –22 °C. The manufacturer however rec-
ommends a cooling temperature of –15 °C to –18 °C for normal usage
and optimum energy consumption.
EN
Operation
19