Setting The Temperature; Selecting The Temperature Units; Using The Battery Monitor - Dometic Bordbar CDF-11 Notice D'emploi

All manuals and user guides at all-guides.com
BordBar CDF-11
Press the "ON/OFF" button (fig.
The "POWER" LED (fig.
When the cooler reaches the preset temperature, the LED lights up
orange.
The display (fig. 2
temperature.
The cooler starts cooling the interior.
5.7

Setting the temperature

Press the "SET" button (fig.
Use the "+" (fig. 2
the cooling temperature.
The cooling temperature appears in the display for a few seconds. The
display flashes several times and then the current temperature is dis-
played again.
5.8

Selecting the temperature units

You can switch the temperature display between Celsius and Fahrenheit.
This is how to do it:
Switch on the cooler.
Press the "SET" button (fig.
Use the "+" (fig. 2
Celsius or Fahrenheit.
The selected temperature units then appear in the display for a few sec-
onds. The display flashes several times before it returns to the current
temperature.
5.9

Using the battery monitor

The device is equipped with a multi-level battery monitor that protects your
vehicle battery against excessive discharging when the device is connected
to the on-board 12/24 V supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set lev-
el. The cooler will switch back on once the battery has been recharged to the
restart voltage level.
2 1, page 2) for three seconds.
2 2, page 2) lights up green.
5, page 2) switches on and shows the current cooling
2 4, page 2) once.
6, page 2) and "–" (fig.
2 4, page 2) twice.
6, page 2) and "–" (fig.
Operation
2 7, page 2) buttons to select
2 7, page 2) buttons to select
11