Setting The Temperature - Dometic CFX Serie Notice D'utilisation

Operation
I
NOTE
Place the cooling box as shown (fig. 1, page 3). If you operate the
cooling box in a different orientation it can be damaged.
2. Connect the cooling box, see chapter "Connecting the cooling box" on
page 16.
A
NOTICE! Hazard from excessively low temperature
Ensure that only those objects are placed in the cooling box that are
intended to be cooled at the selected temperature.
3. Press the "ON/OFF" button (fig. 3 1, page 4) for between one and two
seconds.
✔ The LED "P" lights up (fig. 3 2, page 4).
✔ The display (fig. 3 5, page 4) switches on and shows the current temperature.
✔ The cooling box starts cooling the interior.
I
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED "P" flashes orange.
Latching the cooling box lid
1. Close the lid.
2. Press the latches (fig. 2 1, page 3) down, until they latch in place audibly.
I
NOTE – "Lid open" alarm
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
7.6

Setting the temperature

1. Press the "SET" button (fig. 3 4, page 4) once.
2. Use the "UP +" (fig. 3 7, page 4) and "DOWN –" (fig. 3 6, page 4) buttons to
select the cooling temperature.
✔ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
20
CFX100
EN