Set Brightness Of Displays - Dometic COOLFREEZE CFX95DZW Notice D'utilisation

Operation
Resetting the Wi-Fi to factory settings
In case you have personalized the Wi-Fi settings of your cooling device using the
Wi-Fi app and forgotten your password, you can reset to the factory settings as
follows:
➤ Press the "SET" button (fig. 3 4, page 3) six times.
➤ Hold the "UP +" (fig. 3 10, page 3) button for at least five seconds.
✓ In both displays "rES" will blink several times before returning to the previous
display.
✓ The Wi-Fi settings have been reset to factory settings.
For additional information visit the Dometic website from which you downloaded
the app.
6.9

Set brightness of displays

The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the displays proceed as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 4, page 4) five times.
➤ Use the "UP +" (fig. 3 7, page 4) or "DOWN –" (fig. 3 6, page 4) buttons to
set the brightness of the displays.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The displays show the set mode for some seconds. The displays flash several
times before they return to the current brightness.
I
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically is d0 (default). After
troubleshooting the set brightness is reactivated.
20
CFX95DZW
EN