Setting The Temperature; Using The Battery Protection; Setting The Display's Brightness; Switching On Or Off The Compartments (Only Cfx3 75Dz, Cfx3 95Dz) - Dometic CFX3 Série Notice D'utilisation

Operation
7.9

Setting the temperature

A
NOTICE! Damage hazard from excessively low temperature
Ensure that only those objects are placed in the cooler that are intended
to be cooled at the selected temperature.
➤ Proceed as shown (fig. g, page 11).
7.10

Using the battery protection

The device is equipped with 3-stage battery protection. The battery protection pre-
vents excessive discharging when the device is connected to a vehicle starter battery
or maximises the use of a supply battery.
If the cooler is operated when the vehicle ignition is switched off, the cooler switches
off automatically as soon as the supply voltage falls below a set level. The cooler will
switch back on once the battery has been recharged to the restart voltage level.
A
NOTICE! Damage hazard
When switched off by the battery protection, the battery will no longer
be fully charged. Avoid starting repeatedly. Ensure that the battery is
recharged.
I
NOTE
When the cooler is supplied by a starter battery, select the battery
protection mode "MEDIUM" or "HIGH". If the cooler is connected to a
supply battery, the battery protection mode "LOW" is ideal.
➤ Proceed as shown (fig. h, page 12).
7.11

Setting the display's brightness

➤ Proceed as shown (fig. i, page 12).
7.12 Switching on or off the compartments
(only CFX3 75DZ, CFX3 95DZ)
You can activate each zone individually or both of them.
➤ Proceed as shown (fig. j, page 13).
28
CFX3
EN