Setting The Display's Brightness; Switching On Or Off The Compartments (Only Cfx3 75Dz, Cfx3 95Dz); Using The Ice Maker (Only Cfx3 55Im) - Dometic CFX 3 Serie Notice D'utilisation

Operation
➤ Proceed as shown (fig. g, page 13).
7.11

Setting the display's brightness

➤ Proceed as shown (fig. h, page 13).
7.12 Switching on or off the compartments
(only CFX3 75DZ, CFX3 95DZ)
You can activate each zone individually or both of them.
➤ Proceed as shown (fig. i, page 14).
7.13

Using the ice maker (only CFX3 55IM)

I
NOTE
• Independent of the main compartment's temperature setting, the
ice maker zone is designed for making ice cubes if the ice maker is
switched on.
• The cooler's energy consumption increases with ice maker on.
Therefore you should switch off the ice maker if it is not needed.
• The factory setting for the ice maker is OFF.
➤ Proceed as shown (fig. j, page 14).
Filling the ice trays with water
➤ Remove the ice trays (fig. k 1, page 15) from the ice maker housing (fig. k 2,
page 15).
➤ Remove the ice tray covers, fill with clean water and re-fit the cover, taking care to
press the edge seal all the way around.
➤ Re-position the ice trays in the ice maker housing and close the lid.
I
NOTE
Dry any water spillage from under the ice trays.
This will reduce ice build up under the trays and make removal easier.
Removing the ice cubes
➤ Open the ice maker housing lid and lift under the front of the ice trays.
30
CFX3
EN