Selecting The Temperature Units; Setting The Temperature; Using The Battery Protection; Setting The Display's Brightness - Dometic CFX 3 Serie Notice D'utilisation

CFX3
7.8

Selecting the temperature units

➤ Proceed as shown (fig. e, page 11).
7.9

Setting the temperature

A
NOTICE! Damage hazard from excessively low temperature
Ensure that only those objects are placed in the cooler that are intended
to be cooled at the selected temperature.
➤ Proceed as shown (fig. f, page 12).
7.10

Using the battery protection

The device is equipped with 3-stage battery protection. The battery protection
prevents excessive discharging when the device is connected to a vehicle starter
battery or maximises the use of a supply battery.
If the cooler is operated when the vehicle ignition is switched off, the cooler switches
off automatically as soon as the supply voltage falls below a set level. The cooler will
switch back on once the battery has been recharged to the restart voltage level.
A
NOTICE! Damage hazard
When switched off by the battery protection, the battery will no longer
be fully charged. Avoid starting repeatedly. Ensure that the battery is
recharged.
I
NOTE
When the cooler is supplied by a starter battery, select the battery
protection mode "MEDIUM" or "HIGH". If the cooler is connected to a
supply battery, the battery protection mode "LOW" is ideal.
➤ Proceed as shown (fig. g, page 13).
7.11

Setting the display's brightness

➤ Proceed as shown (fig. h, page 13).
EN
Operation
29